Sharp MX-C401 User Manual

Page 26

Text mode
Original mode

REPLACING SUPPLIES AND MAINTENANCE

Hold the developer cartridge with one hand and
slowly remove the seal with the other hand.

Slowly pull the seal straight and horizontally out.

If excessive force is used or the seal is pulled out diagonally, it may tear.

There is a mark (red belt) on the end of the seal. After removing the
seal, be sure to verify that the mark (red belt) is on the end of the seal.
If the seal has been cut on the developer cartridge, the cartridge cannot
be used. Replace with a new developer cartridge.

Close the main charger cover and rotate the lock
levers in the direction of the arrows to lock the cover.

When the lock levers are vertical, the cover is locked.

mxc401_us_saf.book 23 ページ２００８年１０月１５日　水曜日　午前１１時５２分