Sun Microsystems FC Switch-8 and Switch-16 816-0830-12 - Manual (Page 73)

Chapter 4 Hardware Installation 43
FIGURE 4-1 Attaching the Mounting Rails
3. Working from the front of the cabinet, install the mounting rails by sliding the
keyhole slot in the rail onto the screw.
The rails for left and right are identical, but reversed, for the two sides.
The large hole is oriented near the back for both rails.
Use the slot marked L for the left rail. Use the slot marked R for the right rail.
(
FIGURE 4-2 )
L
Stopper screws
R
Back