Adding a sun storedge a3500fc array, Adding a fc-tape drive, Removing storage devices – Sun Microsystems FC Switch-8 and Switch-16 816-0830-12 User Manual

Page 154

124

Sun StorEdge Network FC Switch-8 and Switch-16 Installation and Configuration Guide • October 2001

Adding a Sun StorEdge T3 Workgroup or
Enterprise Array

The following applies to when the Sun StorEdge T3 array is connected as a Fabric
device (an array to a switch TL_port and a host port to a switch F_port). If Sun
StorEdge Traffic Manager is enabled, refer to “To Configure a Fabric-Connected
Device as a Sun StorEdge Traffic Manager Device” on page 101. If Sun StorEdge
Traffic Manager is not enabled, refer to “To Configure a Fabric Device” on page 91.

Adding a Sun StorEdge A3500FC Array

Use the

boot -r

command after installing RAID Manager 6.22.1 and the first Sun

StorEdge A3500FC array.

You can add additional Sun StorEdge A3500FC arrays without rebooting, but you
must run the

/usr/lib/osa/bin/hot_add

command.

Adding a FC-Tape Drive

See the following documentation for additional information:

■

For the L180:

■

L180 Operator’s Manual

■

L180 Installation Manual

■

L180 Information Manual

■

L180 Assurance Guide

■

For the L700

■

L700 Operator’s Guide

■

L700 Service Manual

■

L700 Systems Assurance Manual

Removing Storage Devices

This section contains the following topics:

■

■

■