Sun Microsystems FC Switch-8 and Switch-16 816-0830-12 - Manual (Page 139)

Chapter 8 Configuring the SAN 109
▼ To Configure All Fabric-Connected Devices on a Sun
StorEdge Traffic Manager Enabled Host Port
In this example, an attachment point id (Ap_Id) on a Fabric-connected host port is a
path to a Sun StorEdge Traffic Manager device. Configuring an attachment point ID
on a Sun StorEdge Traffic Manager device has already been configured through
another attachment point ID will result in an additional path to the previously
configured device; but, a new Solaris device is not created in this case. Note that a
new Solaris device is not created in this case. A Solaris device is created only the first
time an attachment point ID to a corresponding Sun StorEdge Traffic Manager
device is configured.
Maximum prefetch: 0x0
Device Type: Disk device
Path(s):
/dev/rdsk/c6t60020F20000061073AC8B52D000B74A3d0s2
/devices/scsi_vhci/ssd@g60020f20000061073ac8b52d000b74a3:c,raw
Controller /devices/pci@1f,2000/pci@1/SUNW,qlc@5/fp@0,0
Device Address 50020f2300006077,1
Class primary
State ONLINE
DEVICE PROPERTIES for disk: 50020f2300006077
Status(Port B): O.K.
Vendor: SUN
Product ID: T300
WWN(Node): 50020f2000006077
WWN(Port B): 50020f2300006077
Revision: 0117
Serial Num: Unsupported
Unformatted capacity: 558448.000 MBytes
Write Cache: Enabled
Read Cache: Enabled
Minimum prefetch: 0x0
Maximum prefetch: 0x0
Device Type: Disk device
Path(s):
/dev/rdsk/c6t60020F20000061073AC8B4C50004ED3Ad0s2
/devices/scsi_vhci/ssd@g60020f20000061073ac8b4c50004ed3a:c,raw
Controller /devices/pci@1f,2000/pci@1/SUNW,qlc@5/fp@0,0
Device Address 50020f2300006077,0
Class secondary
State ONLINE
CODE EXAMPLE 8-6 (Continued)