Sun Microsystems FC Switch-8 and Switch-16 816-0830-12 - Manual (Page 167)

Chapter 10 Troubleshooting Tools and Resources 137
Corrective Measures
■ Check that the /kernel/drv/scsi_vhci.conf configuration is correct.
■ Make sure mpxio-disable=no is set.
■ Check /var/adm/messages for errors.
■ For Sun StorEdge T3 Array installations, make sure the sys mp_support setting
is set to mpxio .
If the problem persists, contact your Sun Service representative.
Problem
Failing a path (to secondary or to primary) does not succeed using Sun StorEdge
Traffic Manager.
Corrective Measures
■ Check the luxadm display output on the disk/LUN to verify that the secondary
path is STANDBY.
If the path is not STANDBY, it cannot be used as a failover path.