Sun Microsystems FC Switch-8 and Switch-16 816-0830-12 - Manual (Page 121)

Chapter 8 Configuring the SAN 91
Note – The cfgadm -l commands displays information about fibre channel host
ports. Use the cfgadm -al command to also display information about fibre
channel devices. The lines that include a port World Wide Name in the attachment
point ID field associated with
c0 represent a Fabric device. Use the cfgadm
configure and unconfigure commands to manage those devices be made
available on Solaris host. The attachment points with port WWN under c1 represent
private-loop devices that are configured through the c1 host port.
▼ To Configure a Fabric Device
This procedure describes how to configure a Fabric device that is attached to the
Fabric-connected host port
c0 .
1. Become superuser.
2. Identify the device to be configured.
Only the devices on a Fabric-connected host port can be configured.
3. Configure the Fabric device.
# cfgadm -al
Ap_Id Type Receptacle Occupant Condition
c0 fc-fabric connected unconfigured unknown
c0::50020f2300006077 disk connected unconfigured unknown
c0::50020f23000063a9 disk connected unconfigured unknown
c0::50020f2300005f24 disk connected unconfigured unknown
c0::50020f2300006107 disk connected unconfigured unknown
c1 fc-private connected configured unknown
c1::220203708b69c32b disk connected configured unknown
c1::220203708ba7d832 disk connected configured unknown
c1::220203708b8d45f2 disk connected configured unknown
c1::220203708b9b20b2 disk connected configured unknown
# cfgadm -c configure c0::50020f2300006077