Sonance DAB1 - Manual (Page 57)

57
DAB1 DISTRIBUTED AUDIO SYSTEM
6. Drag the macro icon into the Macro Window. This will establish a
button P RESS - AND -H OLD condition (see Figure 81 and Figure 82).
7. In the C OMMAND T YPE drop-down box, select C OMMAND F ROM L IBRARY . The
DAB1 IR commands will reappear in the C OMMAND window
(see Figure 80).
8. Drag the S OURCE 1 command into the Macro Window, above the Else
line, as shown in Figure 82.
9. Click on the S OURCE 1 command you just dragged into the window. the
E DIT I NFRARED C OMMAND window will appear (see Figure 83). Change the
M INIMUM R EPEATS to 6. Click OK.
10. Drag a second S OURCE 1 command into the Macro Window, this time
below the Else line, as shown in Figure 82. Click OK.
Repeat Steps 3 – 10 for each K2 Source button being used in the system.
Now, a Source button P
RESS will activate the source in the zone the keypad
controls. A Source button P RESS - AND -H OLD will activate the source in all
zones in the system (Party Mode).
Figure 81: Programming a K2 Keypad for
P ARTY M ODE , Steps 5 – 6
Step 5:
• Select B
UTTON T EST
Command
• Select H
ELD -D OWN
• Set Time to
1.5 Seconds
Step 6: Drag Icon
Into Edit Window
Figure 82: Programming a K2 Keypad for P ARTY M ODE , Steps 6, 8 and 10
Step 6: Drag
B
UTTON T EST Icon
Into E DIT Window
Step 8: Drag S OURCE 1
Command Above
E LSE Line
Step 10: Drag Another
S OURCE 1 Command
Below E LSE Line
Change M INIMUM R EPEATS to 6
Figure 83: Programming a K2 Keypad for
P ARTY M ODE , Step 9