Sonance DAB1 - Manual (Page 23)

23
DAB1 DISTRIBUTED AUDIO SYSTEM
C o n f i g u r i n g D A B 1 K e y p a d S o u r c e B u t t o n s
The Source Selector Buttons on the DAB1 keypads can be configured to
indicate the specific source components available on the system. The
keypad is shipped with the T
UNER label already in place for Source 1.
1. If the keypad is connected, disconnect it from the DAB1.
2. Do not remove any screws from the keypad.
3. Remove the keypad bezel as shown in
Figure 25. Be careful to not
let any of the rubber button membranes fall off.
II M MP PO OR RT TA AN NT T :: D Do o n no ott tto ou ucch h tth he e e exxp po osse ed d p po orrttiio on n o off tth he e kke eyyp pa ad d
cciirrccu uiitt b bo oa arrd d..
4. Lay the keypad on its back
5. Carefully remove the Source 2 button cap. (If the system is using a
source component other than Tuner for Source 1, start with the
Source 1 button.)
6. Find the label for the Source 2 source component on the Label Sheet
that’s included with the keypad. Separate the label from the sheet
and place it on the Source 2 button’s rubber membrane.
7. Replace the button cap on the Source 2 button‘s rubber membrane.
8. Repeat Steps 5 – 7 for all Source buttons on the keypad.
9. Snap the keypad bezel back into place.
10. Test all buttons for free movement. If any of the buttons are tight or hang up, carefully remove, realign and replace
the keypad bezel.
D A B 1 K e y p a d M o u n t i n g a n d L o c a t i o n
The DAB1 Keypad can be mounted in standard single or double J-box enclosures or P-rings.
NOT E : D o NOT m o u n t t h e DA B 1 k e y p a d i n t h e s a m e e l e c t r i c a l b o x w i t h AC h o u s e w i r i n g , l i g h t
s w i t c h e s , o r a n y o t h e r h i g h - v o l t a ge d e v i c e o r c o n t r o l . T h e k e y p a d c a n s h a re ga n g b o x e s with oth e r
controls such as A/B speaker switches, infrared receiver s and volume controls, i f t h e s e o t h e r d e v i c e s a re
ra t e d a s C l a s s 2 d e v i c e s a c c o rd i n g t o t h e Na t i o n a l E l e c t r i c a l C o d e .
The DAB1 keypad should typically be located near the entrance to a room, similar in height and location to a light switch
(see NOTE, above). Care should be taken to avoid placing the keypad near windows or areas that get direct sunlight that
could interfere with IR receiver operation. If this is not possible, you should disable the keypad’s IR receiver (see page 22).
Avoid mounting keypads in locations that will be exposed to moisture, such as near sinks, showers or bathtubs. If you want
to install keypads outdoors, only install them in a covered area with an appropriate weather-proof box.
Bezel
Button Caps
Source Labels
Button Membrane
Figure 25:
Replacing DAB1 Keypad Source Labels