Siemens Gigaset 75 - Manual (Page 60)

56
Appendix
Gigaset 3070/3075isdn, GB, A31008-G3070-B100-3-7619 giga3070KAP.fm 09.01.01
Step
by
Step
Using the keypad protocol
Under CENTREX, the keypad protocol enables additional services from other
providers to be used, e.g voicemail or announcement services.
Contact your provider for more information on keypad control.
Activating/deactivating automatic keypad switchover
Pressing ’*’ and ’#’ automatically switches the system over to the keypad pro-
tocol. The following dialling codes are transmitted to the exchange as keypad
character sequences. If automatic keypad switchover is deactivated, dialling ’*’
and ’#’ has no effect.
Press for selection menus.
Select using [ ˆ ] and [OK]: Service Set up
→
Settings
→
System settings
→
Spec. function → Dial properties → Auto Keypad .
The activated automatic keypad switchover is highlighted.
Activating the keypad protocol during a call only
This setting only applies to the external call currently in progress.
Press for the menu.
Select using [ ˆ ] and [OK]: Keypad On
The activated keypad function is automatically reset when the call is ended.
Activating the keypad protocol for the current connection
You can switch to the keypad protocol for the duration of the next call.
Press for selection menus.
Select using [ ˆ ] and [OK]: Service Set up
→
Call preparat.
→
Temp. Keypad .
Activating/deactivating the dialling of * and #
This function is important for using telecom features, e.g. querying an answer-
ing machine in the telecom network.
Press for selection menus.
Select using [ ˆ ] and [OK]: Service Set up
→
Settings
→
System settings
→
Spec. function → Dial properties → Dial * and # .
Activated dialling of * and # is highlighted.
1.
2.
1.
2.
1.
2.
1.
2.