Siemens Gigaset C450IP - Manual (Page 57)

56
Web configurator
Gigaset C450 IP / Greek eng / A31008-M1713-T151-3-8U19 / web_server.fm / 24.9.07
Ver
si
on 4, 16.
09.20
05
Access to the Web configurator services
from other networks is only possible if
your router is set accordingly. The router
must pass on the service requests from
"outside" to Port 80 (standard port) of the
phone. Please also read the user guide for
your router.
To establish a connection, the public IP
address or the DNS name of the router
and, where applicable, the port number
on the router, must be indicated in the
Web browser of the remote PC.
Configuring telephone
connections
You can configure two phone numbers on
your phone: your fixed network number
and your VoIP phone number.
You need to set up a VoIP account with
your VoIP provider for your VoIP phone
number. You must save the access data for
the account on your phone. You can
assign a name to each connection (VoIP
and fixed network).
To configure the connections:
¤
Open the following Web page:
Settings
¢
Telephony
¢
Connections .
A list (see Figure 3) with all possible con-
nections will be shown.
The list will show the following:
Name
The default name for the connection
Status
The status of the connection will be
shown for the VoIP connection:
registered
The connection is activated. The phone
has been successfully registered. You
can use the connection to make calls.
Disabled
The connection is deactivated. The
phone is not registering with the corre-
sponding account with the VoIP serv-
ice. You cannot use the connection to
make or receive calls.
Registration failed / Server not accessible
(Examples)
The phone could not be registered with
the VoIP service, e.g. because the VoIP
access data is incomplete or incorrect,
or because the phone is not connected
to the Internet. There is information
about this in the section entitled "Ques-
tions and answers" from page 69.
Active
You can use the option in the Active
column to activate ( ) and deactivate
( ) the VoIP connection. If the connec-
tion is deactivated, the phone will not
register for this connection. The con-
nection can be activated/deactivated by
clicking directly on the option. The
change does not need to be saved.
To configure the connection or to change
the configuration of a connection:
¤
Click on the Edit button next to the con-
nection.
This will open a Web page where you can
make the settings needed. For more infor-
mation, see the "Configuring the VoIP con-
nection" section on page 57.
Figure 3 List of possible connections
Please note:
For Gigaset C450IP base stations manufac-
tured before June 2006, the Web page in
"Figure 3" is not displayed after a firmware
update. For how to configure VoIP connections
on these base stations, please refer to the sec-
tion entitled "Configuring the VoIP connection"
on page 57.