Siemens Gigaset C450IP - Manual (Page 37)

36
SMS (text messages)
Gigaset C450 IP / Greek eng / A31008-M1713-T151-3-8U19 / sms_neutral.fm / 24.9.07
Ver
si
on 4, 16.
09.20
05
Adding a number to the directory
Adding the sender's number
You are reading an SMS in the incoming
message list.
§Menu§ Press the soft key.
For further information, see page 30.
Setting SMS centre
You can set up a maximum of four SMS
centres.
Entering/changing SMS centres
¤
You should find out about the services
and special functions offered by your
service provider before you make a
new application and before you delete
preconfigured phone numbers.
§Menu§
¢
SMS
¢
Settings
¢
Service
Centres
q Select SMS centre (e.g. Service
Centre 1 ) and press §OK§ .
You have the following options:
Active Send Serv. Centre
If the SMS messages are to be sent
through this SMS centre, press §OK§ to
activate the SMS centre ( ‰ = on). If a
different SMS centre was active previ-
ously, then this will be deactivated.
With SMS centres 2, 3 and 4, the set-
ting only applies to the next SMS.
SMS
Enter the number of the SMS centre
and press §OK§ .
Sending an SMS through another SMS
centre
¤
Activate the SMS centre (2 or 3) as the
active send service centre (page 36).
¤
Send the SMS.
This setting only applies to the next SMS
to be sent. After that, the setting returns
to Service Centre 1 .
SMS on a PABX
u You can only receive an SMS when the
Calling Line Identification (page 19)
is forwarded to the extension of the
PABX (CLIP). The CLIP of the phone
number for the SMS centre is evaluated
in your Gigaset.
u Depending on your PABX, you may
have to add the access code (external
line prefix) before the number of the
SMS centre.
If in doubt, test your PABX e.g. by send-
ing an SMS to your own phone number,
once with and once without the access
code.
u When you send SMS messages, your
sender number may be sent without
your extension number. In this case the
recipient cannot reply to you directly.
Sending and receiving SMS on ISDN
PABXs is only possible via the MSN
number assigned to your base station.
Activating/deactivating the SMS
function
When you switch off you cannot send or
receive any SMS messages with your
phone.
Settings which you have made for sending
and receiving SMS messages (the num-
bers of SMS centres) and any entries in the
incoming message and draft message lists
will be retained even after the function is
deactivated.
Please note:
You can create a special directory for SMS mes-
sages within your main directory by putting a
star (*) before the names.
An appended mailbox ID will be copied to the
directory.