SATO CT410 - Manual (Page 90)

Job ID Store
Command Structure IDaa
aa = Job ID assigned (01 to 99)
Example: ID09
Placement: Immediately following the A in the job data stream.
Default: None
Command Function To add an identification number to a job. The status of the job can
then be determined using the ENQ command in the Bi-Com status
mode (See Section 5: Interface Specifications for more information).
Printer Input A
ID02
. . . Job . . .
Z
Printer Output There is no printer output as a result of this command. In the Bi-Com
mode, the Job ID will be returned upon the receipt of a status
request command.
Special Notes 1. Works only in Bi-Com mode. The Job ID number must be stored
before Bi-Com status mode can be used.
2. If more than one ID number is sent in a single job, i.e.
A
ID01
. . . . . . . . . .
ID02
. . . . . . . . .
the last number transmitted will be used.
Section 4. Programming Reference
Page 4-46 9001069 A SATO CT Series Printers