SATO CT410 - Manual (Page 75)

Cut Job
Command Structure aaaa
~aaaa
aaaa = Number of labels to print between each cut (1-9999)
Example: ~2
Placement: Following the Print Quantity command Q
Default: ~1 (if cutter enabled)
Command Function To control the cutting of labels when using a SATO cutter unit with
the printer printer. This command allows the cutting of a multi-part tag
or label at a specified interval within a print job.
Input to Printer: A
H0020V0020XB1ABCQ3
~0002
Z
Printer Output: This set of commands will print 6 labels (3 x 2) with two labels
between each cut.
Special Notes 1. You must have the optional printer Cutter to use this function.
Contact your SATO representative for more information.
2. To use this command, the printer configuration must have the cutter
option enabled. See Printer Configuration commands in this
section manual.
3. If the cutter option has been enabled in the printer configuration
and the cut value (a = 0), the cutter is inactive.
4. The represents the ASCII 00 Hex character. A “~” (tilde)
character or character can be substituted in this command.
5. When using the Cutter command, the total number of labels printed
is the product of the cut value and the print quantity.
ABC ABC ABC ABC ABC ABC
6pc
2pc
Cut Cut Cut
Section 4. Programming Reference
SATO CT Series Printers 9001069 A Page 4-31