SATO CT410 - Manual (Page 161)

IGa Sensor Type. Selects sensor used for label indexing.
a = 0 Reflective (Eye-Mark) Sensor
1 Transmissive (Gap) Sensor
2 No sensor
Page 4-89
I2abcde Serial I/F Set. Sets operating parameters for optional serial interface.
a = Baud rate select
0
9600 BPS
1 19200 BPS
2 38400 BPS
3 57600 BPS
b = Data bit select
0
8 data bits
1 7 data bits
c = Parity Select
0
No parity
1 Odd parity
2 Even parity
d = Stop bit select
0
1 stop bit
1 2 stop bits
e = Protocol select
0
Single Item buffer
1 Multi Item buffer
2 X-On/X-Off Flow Control
3 Bi-Com Status Protocol
4 Bi-Com Status Protocol 3. (Used only for software compatibility)
Page 4-90
J Journal Print. Provides the ability to print text line by line. Fixed
spacing between lines and characters. Page 4-47
Kab90cc Recall Custom Designed Characters. Recalls for printing a custom
character stored by the Tabcc(data) command.
a = 1 16 x 16 matrix
2 24 x 24 matrix
b = Indicates the format that data stream was stored in
B
Binary
H Hexadecimal
bb = Memory location where the character was stored.
Valid locations are 21 to 52 or “!” to “R” in hex values.
Page 4-19
Laabb Character Expansion. Expands characters in both directions.
aa = Multiple to expand horizontally (01-12)
bb = Multiple to expand vertically (01-12)
Page 4-21
LDa,b,c,d,e,f,g,i Protocol Code Select. Selects the hexadecimal protocol codes to be
used. See Section 4: Programming Reference for details.
Page 4-82
M Font type. Specifies the 13W x 20H dot matrix font (including
descenders). Page 4-34
INSTRUCTION DESCRIPTION PAGE
Appendix A: Command Quick Reference
Page A-6 9001069 A SATO CT Series Printers