Schneider Electric 66123 - Manual (Page 45)

Network Management Card & Modbus/Jbus 34022321XT indice :AE Page 45/98
Network Management Teleservice Card
APC by Schneider Electric
www.apc.com
Configuration: shows where the parameters of the Network Shutdown Module come from: Local (coming from the application) or Central
(coming from the card).
The Central shutdown configuration is available by clicking on the Configuration link.
Shutdown duration: the shutdown duration necessary to properly shutdown the computer.
Shutdown after: the time available to the user from the power failure until the launch of the shutoff sequence of the UPS and equipment. This
parameter is optional.
Many actions are available on this page:
Remove: Depending on the kind of application, the selected ones will definitively disappear from the table as SNMP applications, or they will
disappear and automatically re-subscribe as Network Shutdown Module applications.
Utility failure Test: Two alarms, 'Utility failure' and 'Utility restored' spaced 60 seconds apart, will be sent to the applications selected, making sure
that the applications can be reached over the network.
Shutdown Test: This test simulates a UPS on battery operation. It enables an easy check to see if the server protection works correctly.
- No intervention on the UPS is required.
- The applications selected will process the simultaneous alarms and perform an actual shutdown sequence.
WARNING!
- This test will generate a REAL shutdown sequence of the selected servers on which the Network Shutdown Module application is
running.
Add NMS: allows an SNMP trap receiver to be added such as a Network Management System.
Modify NMS: allows an SNMP trap receiver to be modified.
Both buttons open a new window where it is possible to enter the Application name, the Hostname or IP Address, the Trap community
and the severity.
The default severity value is 1 - Warning