Siemens Simotion A4027118-A0414 - Manual (Page 56)

Section B: The application example as demonstration
system
O t t l f th li ti l
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 56/107
C
opyr
ight
©
Si
em
ens
AG 2
0
08
Al
l r
ights r
e
s
e
rv
ed
M
anual_
S
IM
OTION Fl
ying Saw
_
V1
.4.
d
oc
8 Depending on the material velocity and the cutting
duration, an actual maximum position of the flying saw is
obtained, which is identified by a
red bar.
9 You can start to thread the material web or continue
motion after the material web was stopped by pressing
the Material START button.
10 If the flying saw has synchronized itself to the motion of
the material web, the flying saw is in the AUTOMATIC-
PRODUCING mode.
11 Here, you can select whether a cutting position is to be
generated at each print mark (sensor signal) or only after
n print marks.
12 You can stop the material web using the Material BREAK
button.
13 When the material web has been stopped, the flying saw
is in the AUTOMATIC-HELD mode
14 You can start to remove the material web from the system
by pressing the Material END button.
15 The flying saw then waits in the AUTOMATIC-STANDBY
mode for the next material web.