Siemens Simotion A4027118-A0414 - Manual (Page 41)

Section B: The application example as demonstration
system
O t t l f th li ti l
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 41/107
C
opyr
ight
©
Si
em
ens
AG 2
0
08
Al
l r
ights r
e
s
e
rv
ed
M
anual_
S
IM
OTION Fl
ying Saw
_
V1
.4.
d
oc
5 Operator control of the application example
The application can be used to present SIMOTION D with SINAMICS and
get to know and test the functions of the CPU D435.
You will find brief instructions on how to demonstrate and present the
application in the following Chapter 5.1 Brief instructions to
demonstrate.
You will find a detailed description of all of the operator screens in Chapter
5.2 Detailed operating instruction
5.1 Brief instructions to demonstrate
Here, in these instructions you will only be shown and explained the steps
necessary to demonstrate the application. Not all of the operator screens
are discussed.. A detailed description of all operator screens is provided in
Chapter 5.2 Detailed operating instruction.
Prerequisites
The following prerequisites must be fulfilled to use the application example:
• The SIMOTION project is provided online in SIMOTION D435.
• The parameterization for the applications has been downloaded into
SINAMICS. (also included in the SIMOTION project!)
• All of the devices are powered-up.
• The SIMOTION D435 has been switched into the “Run” state using the
online function of SIMOTION SCOUT.
• At least WinCCflex Advanced 2007 Hotfix 4 is installed on the PC/PG.
Note WinCCflex requires the appropriate authorization. Authorization for at
least 256 power tags is required.