Siemens Simotion A4027118-A0414 - Manual (Page 27)

Section B: The application example as demonstration
system
I t lli th h d d ft
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 27/107
C
opyr
ight
©
Si
em
ens
AG 2
0
08
Al
l r
ights r
e
s
e
rv
ed
M
anual_
S
IM
OTION Fl
ying Saw
_
V1
.4.
d
oc
Table 4-2 Hardware configuration and mounting
No. Action Comment
1 Connect the MPI/DP interface of your PG/PC
to the righthand MPI/DP interface (contact
X136) of the SIMOTION D435 using a
PROFIBUS cable and switch the terminating
resistors in the two terminating connectors of
the cable to “On”.
Do not use the standard MPI cable,
supplied with the PG/PC to connect the
PG/PC to the SIMOTION D435!
The connection should be operated with a
12Mbit/s baud rate. Under all
circumstances, a PROFIBUS cable must
be used between the PG/PC and
SIMOTION D435 with the terminating
resistors switched-in. If this is not done,
communication problems can occur
between the PG/PC and the SIMOTION
D435.
2 Connect the SIMOTION D training case to
the power supply.
3 Power-up all of the equipment/devices.