Siemens Simotion A4027118-A0414 - Manual (Page 43)

Section B: The application example as demonstration
system
O t t l f th li ti l
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 43/107
C
opyr
ight
©
Si
em
ens
AG 2
0
08
Al
l r
ights r
e
s
e
rv
ed
M
anual_
S
IM
OTION Fl
ying Saw
_
V1
.4.
d
oc
5.1.2 Brief instructions
Execute the following steps in the sequence as listed in the following table
to demonstrate the application example:
Table 5-1: Brief instructions to demonstrate/present the “flying saw” application example
No. Action Comment
1 Call the following file
"C:\Siemens\Step7\S7Proj\SAP_FlyingSaw\TDOP\
PRO__00.fwd"
.
As an alternative, you can also select the operator panel
using Step 7. In the SIMATIC Manager, open the
SAP_FlyingSaw project. You will find the HMI object
OP1 at the project level. Start the runtime from the
context menu (righthand mouse key).
2 If the connection to the CPU was able to be established,
the screen form appears at the top left - mode: Idle
Check that your PG/PC is set
to PROFIBUS with 12 Mbit/s.
3 At the bottom left, please click on AUTO
(3 rd button from the left!)
4 First activate the print mark simulation by pressing the
Print Mark Simulation ON / OFF
button.
5 Next, activate the travel to the starting position using the
button Flying Saw STARTPOS