Siemens Simotion A4027118-A0414 User Manual
Page 36
Section B: The application example as demonstration
system
I
t lli
th h d
d
ft
Flying Saw with SIMOTION
A4027118-A0414
V 1.4
Release 06/06/08
36/107
C
opyr
ight
©
Si
em
ens
AG 2
0
08
Al
l r
ights r
e
s
e
rv
ed
M
anual_
S
IM
OTION Fl
ying Saw
_
V1
.4.
d
oc
3 The Ethernet interface IE2 (X130) of
SIMOTION D435 has, as standard, the
IP address 169.254.11.22.
Select “Use the following IP address”
and enter the IP address 169.254.11.23.
Enter 255.255.0.0 as “Subnet mask”.
4 The address set above must be identical
to the address for the PG/PC. Check this
address by selecting the PG/PC
interface in Netpro and, if required,
modify this.
5 Acknowledge your changes by pressing
twice on OK.
4.4.5
Downloading the hardware configuration after a factory setting
To download the hardware configuration, please proceed as follows
Table 4-4: Downloading the hardware configuration after a factory setting
No.
Action
Comment
1 Now go into the hardware configuration
and press the Download to target
module button