Siemens Simotion A4027118-A0414 - Manual (Page 10)

Section A: Prerequisites and objectives
Basic information
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 10/107
C
opyr
ight
©
Si
em
ens
AG 2
0
08
Al
l r
ights r
e
s
e
rv
ed
M
anual_
S
IM
OTION Fl
ying Saw
_
V1
.4.
d
oc
Section A: Prerequisites and objectives
Content
Section A will provide you with everything that you require to obtain an
overview of this standard application. The prerequisites and the objective
for using this standard application are presented.
The applications shown will give you a good understanding for what this
standard application can be used for. Further, some applications will be
listed for which this standard application cannot be used. In addition, the
performance limits of this standard application will be shown.
Objective
Section A of this document should provide the user with the following
information:
• The objective and purpose of this standard application
• List
several applications
• Indicate the performance limits of this standard application.
Subjects discussed
Chap. Title Contents
1 Basic information The necessary prerequisites to use the standard “flying saw”
application.
The use of this application.
Software components and code blocks of the standard
“flying saw” application.
2 Uses Tasks and properties of the core functions of the standard
“flying saw” application
Exclusions and restrictions
Hardware components required
3 Structure and
function Type of design and physical quantities for which the “flying
saw” core function can be used.
Type of cams that the “flying saw” core functions calculate
and used.
Operating states at the FlyingSaw FB.
4 Program
environment and
interfaces Call environment of the FlyingSaw FB
Description of the interfaces and the parameters of the
FB_BGD_TEMPLATE_FlyingSaw()