Siemens Simotion A4027118-A0414 - Manual (Page 24)

Section B: The application example as demonstration
system
I t lli th h d d ft
Flying Saw with SIMOTION A4027118-A0414
V 1.4 Release 06/06/08 24/107
C
opyr
ight
©
Si
em
ens
AG 2
0
08
Al
l r
ights r
e
s
e
rv
ed
M
anual_
S
IM
OTION Fl
ying Saw
_
V1
.4.
d
oc
4.1.2 Responsibilities of the operator
Correct use
The correct use of the application components exclusively relates to the
open-loop and closed-loop control of test set-ups that were adapted to the
power/performance of the application components. In order that the
application functions perfectly, the required standard SIMATIC components
as well as also the necessary hardware and software components must be
installed.
The company/person operating the system may only make changes to the
application components after having received written authorization from the
suppliers.
Misuse
The following are considered to be misuse:
• Inadmissible loads applied to the application components.
• Any application deviating from the use specified above, or applications
that go beyond the specified use.
• Non-observance of the safety information and instructions.
• If faults that could have a negative impact on the safety are not
immediately resolved/removed.
• Any changes/modifications to equipment/devices that are used to
ensure perfect function and operation, unrestricted use as well as active
or passive safety.
• If recommended hardware and software components are not used.
• If the application components are not in a perfect technical condition are
not operated conscious of safety and hazards, and not taking into
account all of the instructions provided in the documentation.
The manufacturer assumes no liability for incorrect use (misuse).
Responsible for monitoring
The company or person operating the system is responsible in continually
monitoring the overall technical status of the application components
(defects and damage that can be externally identified as well as changes in
the operating behavior).
The company/person operating the system is responsible in ensuring that
the application is only operated in a perfect state. He must check the state
of the application components before they are used and must ensure that
any defect is removed before commissioning.