Juniper Networks E-Series - Manual (Page 97)

7
Powering Up E-Series
Routers
This chapter describes how to power up an E-series router and determine
if it has booted properly.
Before You Power Up the System
Before powering up the system, you should complete the tasks shown in
Table 7-1 . Refer to the appropriate chapters in this guide for information
about these tasks.
Warning: Be sure the power source is turned off and the system is turned off
before you perform the installation tasks.
Topic Page
Before You Power Up the System 7-1
Powering Up 7-2
Status LEDs 7-3
Powering Down 7-3
The Next Step 7-3
Table 7-1 Installation tasks
Installation Task Page
Install an SRP module and SRP I/O module 5-7
Install line modules and their corresponding I/O modules. 5-10
Cable all SRP I/O modules. 6-5
Connect a management console to the system. 6-7
(Optional) Connect the 10/100Base-T port to the network. 6-7