Juniper Networks E-Series - Manual (Page 222)

APPENDIX B
Installing JUNOSe Software B-10
4 Set an IP address on the interface.
host1#configure
Configuring from terminal or file [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#interface fastEthernet 6/0
host1(config-if)#ip address ipAddress [ mask ]
5
Press to return to Privileged Exec mode.
Task 5: Configure Access to the Network Host
To configure access to the network host:
1 Use the ping command to determine whether the E-series router
can reach the network host.
host1#ping ipAddress
If the E-series router can reach the network host, go to the next
section. Otherwise, go to step
2 .
2
Determine whether a route exists between the E-series router and the
network host.
host1#show ip route
If the appropriate route is displayed, go to step 4 . Otherwise, proceed
with step 3 .
3
Configure a route to reach the network host.
host1#configure
Configuring from terminal or file [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#ip route ipNetwork networkMask ipNextHop
4
Press to return to Privileged Exec mode.
5 Determine whether the E-series router has been configured to
recognize the network host.
host1#show host
If the network host is listed, go to step 8 . Otherwise, proceed with
step 7 .
6 Add an entry to the Static Host Table so that the E-series router can
access the network host. The
host command allows you to specify
the network host name and IP address.