Juniper Networks E-Series - Manual (Page 76)

CHAPTER 5
Installing Modules 5-16
Verifying the Installation
To verify that the installation is complete:
1
After you have cabled the system for power (see Chapter 6, Cabling
E-Series Routers ), turn on the power switches.
The system reboots.
2
Issue the show redundancy command, and verify that the display
shows the redundancy hardware.
Configuring Line Module Redundancy
For information about configuring line module redundancy, refer to
E-Series System Basics Configuration Guide, Chapter 5, Managing Line
Modules and SRP Modules
.
The Next Step
After you install the modules, you can connect cables to the system. Turn
to
Chapter 6, Cabling E-Series Routers .