Troubleshooting – JVC VR-509E User Manual
Page 96
Explanations
96
Problems Related to Error Code and On-screen Display
*1 to *3: See the next page
Troubleshooting
On-screen Message
Cause and Recovery
Refer
to
Page
“E-01 DETECTED.” *1, *2
•
System restarted due to error in the functioning of the hard disk.
•
Continues operation with the intact hard disk.
→ Switch the power supply off and then on again, and try the formatting or
defrag functions once again.
→ Consult your nearest JVC dealer.
–
“E-02 NO IDE 1 HDD”
“E-02 NO HDD”
“E-02 IDE 1 FORMAT NG”
“E-02 MIRRORING NG”
•
Abnormality with hard disk operations (cannot be started up.)
→ Switch the power supply off and then on again, and try the formatting or
defrag functions once again.
→ Consult your nearest JVC dealer.
–
“NO VIDEO IN** INPUT (E-03)” *2
•
No video input signals.
→ Stop operations and check the connection.
→ Double-check settings in the [CAMERA SETUP-1] Menu.
* Recording may fail if it is continued after the error message is displayed. Set
the [CAMERA] setting to “DISCONNECT” in the [CAMERA SETUP-1] Menu
or eliminate the cause of the error immediately.
“E-05 DETECTED.” *1, *2
•
Error in the fan motor.
→ Consult your nearest JVC dealer.
–
“E-06 DETECTED.” *1, *2
•
EEPROM error.
→ If this error occurs due to alteration of a menu setting, turn the equipment
off/ on and check the setting.
→ If this error keeps occurring due to alteration of a menu setting or during
operation, consult your nearest JVC dealer.
–
“E-07 DETECTED.” *1, *2
•
Codec 1 error. (Mostly used for recording and VR-509 playback)
*
HDD/DVD playback, and recording onto the HDD will not be carried out
normally if this is displayed.
→ Consult your nearest JVC dealer.
–
“E-08 DETECTED.” *1, *2
•
Codec 2 error. (Mostly used for transmission and DVD trans-coding)
*
USB still image capturing, DVD export processing and live/playback
transmission to the network will not be carried out normally if this is
displayed.
→ Consult your nearest JVC dealer.
–
“E-09 DETECTED.” *1, *2
•
Error on one of the built-in hard disk drives. (This error is detected only
when in the Mirroring Setting mode.)
→ Consult your nearest JVC dealer.
–
“E-10 DETECTED.”
•
Abnormality with the DVD drive.
→ Consult your nearest JVC dealer.
–
“POWER FAILURE” *2
“The power failure return by UPS
was executed.”
•
Displayed when a power fail occurs.
→ This is not an error. Press the [CANCEL] button to clear the message.