JVC VR-509E - Manual (Page 53)

53
Useful Features
• The capacity of the hard disk will be reduced by
approximately half when mirroring is set up. It is therefore
necessary to take care when setting recording times.
• Mirroring can only be set up for the built-in hard disk, and is
not possible on the external hard disk.
• Setting the system for mirroring is not a guarantee that
data will not be damaged.
• All events logged on the built-in hard disk and the external
hard disk will be deleted when mirroring is set up. It is
therefore necessary to take back-ups of all important
events beforehand.
• Depending on the recording settings and the operational
status, there is a possibility that playback speed will be
reduced and that the sound will not be synchronized with
the images when setting up the system for mirroring. This
is not a malfunction.
• If a power failure occurs which the mirroring settings
enabled, the re-creation process will be carried out once
again in the background. The safety of the recorded data
cannot be guaranteed while the recreation process is being
performed.
• Depending on the condition of the hard disk, there is a
possibility that the mirroring settings will fail. In this event,
cancel the mirroring settings, and then begin the setup
process once again.
• Recording and playback is not possible when the mirroring
settings are being processed.
• As the hard disk capacity displayed on the screen is
calculated as 1GB = (1024) 3 bytes, a lower capacity than
actually exists will be displayed.
• If a defect occurs on one of the hard disks, the function for
exporting data onto DVDs will not operate.
• The objective of mirroring is to protect recorded data in the
event that the VR-509 hard disk malfunctions. Note that
there are cases where operations cannot be continued
even when mirroring has been set up depending on the
case of hard disk malfunction.
It is possible to delete only the alarm lists without disturbing the
alarm recorded images.
1. Press the [MENU] button.
• The [MENU]
→ [OPERATION MENU] →
[MAINTENANCE] screens will be displayed in this
sequence in accordance with the [MENU Screen
Operations] explained on page 17.
2. Select [ALARM LIST CLEAR] with the [ S/T] keys, and
then press [SET].
• The confirmation screen will be displayed.
3. Select [YES] and press the [SET] button.
• The alarm list will be deleted.
* Select the [NO] button to close the confirmation screen.
* The image data for which the alarm list clear process has
been performed are handled as normal recording events.
* Press the [CANCEL] button to abort the deletion process.
Image data for which the alarm list clear process has been
performed until halted become normal recording events.
Setting up the Hard Disk for Mirroring
(continued)
Precautions When Setting up Mirroring
Deleting Alarm Lists
MAINTENANCE
AUTO SCAN DISK
MANUAL SCAN DISK
ALARM LIST CLEAR
DEFRAG DATABASE ..
FORMAT ..
MIRRORING ..
PASSCODE SET ..
MAINTENANCE/LOG ..
AREA SELECT .. OFF
EXEC
EXEC
2.
The alarm list cannot be cleared when in the following
operation modes:
• During recording.
• During the playback of recorded images.
• When the timer is ON.
• During DVD export.
• When a malfunction occurs with the hard disk.
CAUTION