JAI VIS-CAM System TS-1327EN - Manual (Page 97)

Appendix D: Pluggable Terminal Blocks 85
VIS-CAM System
8 Appendix D: Pluggable Terminal Blocks
The connectors on the VIS CAM 300 IO Board and J-Panel are pluggable terminal blocks with pin
spacing of 3.81 mm/ 0.15 inch from WAGO. The contacts are spring loaded.
Figure 86. Terminal block
Table 36 Essential specifications for the pluggable terminal block.
Cross section from [mm²] 0,08 mm²
Cross section to [mm²] 1,5 mm²
Cross section from [AWG] 28 AWG
Cross section to [AWG] 14 AWG
Measured voltage EN 250 V
Measured shock voltage 2,5 kV
*Pollution degree 2
Current intensity EN 10 A
Strip length from 7 mm
Strip length to 7 mm
Strip length 0,28 in
When mounting the wire into the connector the wire is stripped 7mm. The connector spring is
released by using one of two tools:
WAGO 734-230
JAI 2900.00.249
WAGO 210-250
JAI 2900.00.250
The wire is inserted and the spring is activated.