JAI VIS-CAM System TS-1327EN - Manual (Page 96)

VIS-CAM System
84 Appendix C: Two Cameras, One-Flash Configuration
Table 35 Master to slave connections.
Master Flash Connector (X5) Slave Laser Connector (X7)
Pin 2 Pin 2
Pin 3 Pin 3
Pin 5 Pin 1
• Junction Panel trigger polarity switch in position “positive going edge”
• Master camera flash must be set to “auto” in Properties section of ENSetup software
• Slave camera flash must be set to “light sensor control” in properties section of ENSetup
software