JAI VIS-CAM System TS-1327EN - Manual (Page 50)

VIS-CAM System
38 System Set-Up
Figure 32. Roll Bar Display example.
Pan the camera mount until the plate stand is centered under the default position of the vertical
line in the middle of the “Roll Bar” display. Securely tighten the pan bolt. Be careful not to change
the pan of the camera while you tighten the bolt. Oppositely twisting two 9/16" closed-end
wrenches is recommended (one for the bolt head and one for the nut) to help prevent the pan from
moving while you tighten the bolt.
Switch back to the “Tilt Line” display. Tilt the camera mount until the plate is positioned just above
the tilt line. Re-adjust the zoom as necessary until the plate just fits in between the zoom markers
on the “Tilt Line”. Changing zoom usually requires that the tilt adjustment be modified also. Do not
tighten the Tilt bolts until after the final lens adjustment. See Figure 33.