JAI VIS-CAM System TS-1327EN - Manual (Page 35)

Installing the Vehicle Imaging Subsystem 23
VIS-CAM System
3.3 Installing the J-Panel
The J-panel layout is shown in Appendix A, See “Connection requirements.” on page 43. This
Appendix has a detailed description of the J-Panel function and connectors.
3.3.1 X1 and X2 VIS CAM 300/400
The VIS CAM connections to the J-Panel are shown in Table 3 and Figure 20
Table 3 VIS CAM connections to the J-Panel.
X1, X2 Pin # Wire Color Signal Remarks
1 White/orange in Cat5e/6 cable Ethernet A+
2 Orange in Cat5e/6 cable Ethernet A-
3 White/green in Cat5e/6 cable Ethernet B+
4 Green in Cat5e/6 cable Ethernet B-
5 White/blue in Cat5e/6 cable Ethernet C+ not used with VIS CAM
6 Blue in Cat5e/6 cable Ethernet C- not used with VIS CAM
7 White/brown in Cat5e/6 cable Ethernet D+ not used with VIS CAM
8 Brown in Cat5e/6 cable Ethernet D- not used with VIS CAM
9 Black wire in Red/Black pair Gnd
10 Red wire in Red/Black pair +24V dc
11 White wire in Brown/White pair Vinit+ Trigger signal
12 Brown wire in Brown/White pair Vinit- Trigger signal
13 White wire in Red/White pair RS485D+ Lane Controller
14 Red wire in Red/White pair RS485D- Lane Controller
15 White wire in Orange/White pair RS485D+ Lane Controller
16 Orange wire in Orange/White pair RS485D- Lane Controller