MITSUBISHI ELECTRIC MR-J2S- A - Manual (Page 63)

3 - 16
3. SIGNALS AND WIRING
Control
mode
Signal Symbol
Connector
pin No.
Functions/Applications
I/O
division
P S T
External torque
limit selection TL CN1B
9
Turn TL off to make Internal torque limit 1 (parameter No. 28)
valid, or turn it on to make Analog torque limit (TLA) valid.
For details, refer to section 3.4.1 (5). DI-1
Internal
torque limit
selection TL1 When using this signal, make it usable by making the setting of
parameter No. 43 to 48.
For details, refer to section 3.4.1 (5). DI-1
Used to start the servo motor in any of the following directions.
(Note) Input signals
ST2 ST1
Servo motor starting direction
Forward
rotation start ST1 CN1B
8
0 0 Stop (servo lock)
0 1 CCW
1 0 CW
1 1 Stop (servo lock)
Reverse rotation
start ST2 CN1B
9
Note. 0: off
1: on
If both ST1 and ST2 are switched on or off during operation, the
servo motor will be decelerated to a stop according to the
parameter No. 12 setting and servo-locked.
DI-1
Used to select any of the following servo motor torque generation
directions.
(Note) Input signals
RS2 RS1
Torque generation direction
Forward
rotation
selection RS1 CN1B
9
0 0 Torque is not generated.
0 1
Forward rotation in driving mode /
reverse rotation in regenerative mode
1 0
Reverse rotation in driving mode /
forward rotation in regenerative mode
1 1 Torque is not generated.
Reverse rotation
selection RS2 CN1B
8
Note. 0: off
1: on
DI-1