MITSUBISHI ELECTRIC MR-J2S- A - Manual (Page 397)

Print data *Manual number Revision
Oct.,2002 SH(NA)030006-D Section 13.1.5 (1): Configuration diagram reexamination
Note sentence addition
Addition of connector sets and monitor cables
Section 13.1.5 (2): POINT sentence addition
Section 13.1.9 (2)(a): Reexamination
Section 13.2.1 (1): Reexamination
Section 13.2.3: Reexamination
Section 13.2.4: Addition
Section 13.2.8 (1): Leakage current breaker addition
Section 13.2.9 (1): EMC filter addition
Section 14.1.2 (2): Personal computer connector corrected to D-SUB9
Section 14.11: Addition of POINT
Section 14.12.7 (2)(d): Addition
Jun., 2003 SH(NA)030006-E Safety Instructions 1. To prevent electric shock: Sentence addition
3. To prevent injury: Sentence addition
4. Additional instructions: Partial sentence change
COMPLIANCE WITH EC DIRECTIVES 2. (6) (a): Addition
Section 1.3: Inrush current addition
Section 3.6.2 (3) (a) 1): Partial figure change
Section 3.6.2 (3) (b) 1): Partial figure change
Section 3.8.3: Partial figure change
Section 3.13.3: Partial terminal box inside figure change
Section 4.2: CAUTION sentence addition
Section 5.1.2 (2): Parameter No. 0 Addition of (The built-in regenerative
resistor is used.) to "Regenerative option is
not used"
Addition of FR-CV to the setting of 01 in
Selection of regenerative option
Partial sentence deletion
Parameter No. 20 Addition of sentence to Slight vibration
suppression control
Section 5.2.1 (3): Servo amplifier, Electronic gear, 3000r/min changed to
2048/125
Servo amplifier, Electronic gear, 2000r/min changed to
4096/375
Section 6.4 (2): Sentence change
Section 6.6 (3) (a): In position LNP changed to INP
Section 10.2.1: Partial sentence change
Section 10.2.2: AL. 12 to 15 Contents reexamination
AL. 37 Addition of Cause 3
AL. 50 Partial contents change
AL. 51 Addition of "During rotation: 2.5s or more"
Section 12.3: Change of sentence that explains "te"
Section 12.5: Addition
Section 13.1.1 (4) (d): Partial connection diagram change
Section 13.1.2: Addition of "When using the brake unit, set "01 " in
parameter No. 0"
Section 13.1.3: Addition of "When using the power regeneration converter, set
"01 " in parameter No. 0"
Section 13.1.3 (2): Partial connection diagram change
Section 13.1.4 (2): Partial connection diagram change
Section 13.1.10: Addition