Bios post codes, Table, Aaaaaaa – Motorola ATCA-717 User Manual
Page 96: Standard bios post codes
BIOS
BIOS Post Codes
96
PENT/ATCA−717
BIOS Post Codes
The following table lists BIOS post codes applicable to the used Phoenix 4.0 Release 6.0
BIOS. The BIOS POST codes are stored in the blade
′s Port 80 register and can also be
obtained by reading an on−board IPMI sensor. For details refer to
the
a
PENT/ATCA
*715/717/7105/7107: Control via IPMI Programmer’s Guide which can
be downloaded from the Motorola literature catalog.
aaa
Table 9:
Standard BIOS Post Codes
Post Code
Description
02
Verify real mode
03
Disable non−maskable interrupt (NMI)
04
Get CPU type
06
Initialize system hardware
07
Disable shadow and execute code from the ROM
08
Initialize chipset with initial POST values
09
Set IN POST flag
0A
Initialize CPU registers
0B
Enable CPU cache
0C
Initialize caches to initial POST values
0E
Initialize I/O component
0F
Initialize the local bus IDE
10
initialize power management
11
Load alternate registers with initial POST values
12
Restore CPU control word during warm boot
13
Initialize PCI bus mastering devices
14
Initialize keyboard controller
16
BIOS ROM checksum
17
Initialize cache before memory autosize
18
8254 programmable interrupt timer initialization
1A
8237 DMA controller initialization
1C
Reset programmable interrupt controller
20
Test DRAM refresh
22
Test 8742 keyboard controller