Motorola ATCA-717 - Manual (Page 150)

Troubleshooting Error List
150 PENT/ATCA−717
Error List
A typical ATCA system is highly sophisticated. This chapter can be taken as an error list
for detecting erroneous system configurations and strange behaviors. It cannot replace a
serious and sophisticated presales and postsales support during application development.
If it is not possible to fix a problem with the help of this chapter, contact your local sales
representative or Field Application Engineer (FAE) for further support.
Problem Possible Reason Solution
Blade does not work Backplane voltage is too
low. Check that all backplane
voltages are within their
specific ranges.
Check that power supply is
capable to drive the
respective loads.
Blade does not start No valid BIOS was found. Make sure a valid BIOS
PROM is installed