beautypg.com

Rear transition modules – Motorola ATCA-717 User Manual

Page 53

background image

Rear Transition Modules

Installation

PENT/ATCA−717

53

Rear Transition Modules

At the time of writing this manual the following Rear Transition Modules (RTMs) was
available for the blade: ACC/ARTM−717

aa

It provides the following interfaces:

a

S Two USB 2.0

S Two RS−232

S Keyboard/Mouse

S One serial ATA

S Four RS−232 interfaces routed from PMC modules installed on the base blade

Note:

a

S Refer to the RTM documentation for the RTM installation procedure
S Check the documentation of the system where you operate the blade and the RTM

for any restrictions that may apply to the blade or the RTM

S No hot−swap is supported for the RTMs

The RTM furthermore incorporates an Intelligent Platform Management Interface
Controller (IPMC) which enables you to monitor the RTM’s temperature and voltage
sensors. For further information, refer to the

a

ACC/ARTM−715/717/7105/7107: Control via

IPMI Programmer’s Guide

a

which can be downloaded from the former Force Computers

S.M.A.R.T. server or the Motorola literature catalog.

a