Serial console redirection, Requirements, Default configuration – Motorola ATCA-717 User Manual
Page 84: Table, Aaaaaaa, Key codes for terminal emulation program
BIOS
Serial Console Redirection
84
PENT/ATCA−717
Serial Console Redirection
The firmware of the blade provides a serial console redirection feature. This allows
remote blade configuration by connecting a terminal to the blade via a serial
communication link.
a
The terminal can be connected to display VGA text information. Terminal keyboard input
is redirected and treated as a normal PC keyboard input. The serial console redirection
feature can be configured via setup utility.
Note:
a
If serial console redirection is enabled the terminal represents an option and is
not necessarily required for boot−up procedure.
a
Requirements
For serial console redirection, the following is required:
S Terminal which supports a VT100 or ANSI mode
a
S NULL−modem cable
Terminal emulation programs such as TeraTermPro can be used. In order to use
TeraTermPro via the function keys, the keyboard configuration file of TeraTermPro has to
be modified as follows:
Table 8:
Key Codes for Terminal Emulation Program
Function Key
Key Code
PF1
59
PF2
60
Default Configuration
By default, the blade can be accessed via the serial interface COM1. This interface is, by
default, accessible via an installed RTM through an RJ−45 connector. If no RTM is present
or you wish to access COM1 from the blade’s face plate, COM1 can alternatively be made
accessible at an installed CMC module. Whether COM1 is available via RTM or CMC
module depends on the setting of the on−board switch SW3−4 which enables/disables
COM port swapping. The following table provides details.
aaa
Setting of SW3−4
COM1 is accessible via:
OFF (default)
RTM (upper serial connector)
ON
CMC module (upper serial connector)