beautypg.com

Installation procedure, Removal procedure – Motorola ATCA-717 User Manual

Page 48

background image

Installation

On−Board Hardware Accessories

48

PENT/ATCA−717

S Limited Power on PMC Modules and RTMs

The blade does not provide an extra fuse for PMC modules and RTMs.
PMC modules and RTMs used together with the blade have to be qualified
according to the following standards: IEC 60950−1, EN 60950−1, UL 60950−1,
CAN/CSA C22−2 No 60950−1

S Excession of blade‘s power consumption

Exceeding the maximum combined power dissipation of installed PMC modules
may damage the blade.

a

Make sure that the combined power dissipation of installed PMC modules on the
3.3V and 5V rail does not exceed 60W.

S PMC Module Malfunctioning

Processor PMC modules (as defined in ANSI/VITA 32−2003) can be operated in two
different modes: monarch and non−monarch mode.

a

Make sure to operate any installed processor PMC modules (as defined in
ANSI/VITA 32−2003) only in non−monarch mode.

a

S Damage of Installed Hard Disk

If PPMC/270 or PPMC/280 modules are installed into PMC slot 1 or 2, the heat
radiated by the heat sink of theses PMC modules heats up an installed hard disk
that may be installed at the same time.

a

If PPMC/270 or PPMC/280 modules are installed into PMC slot 1 or 2, make sure not
to have a hard disk installed at the same time.

a

S Damage of Rear Transition Module and Blade

The ACC/ARTM−717 was designed to be used in conjunction with PPMC/270 or
PPMC/280 modules modules installed on the blade at the same time.
In order to avoid damage of the blade or RTM, only use the ACC/ARTM−717 in
conjunction with PPMC/270 or PPMC/280 modules.

Installation Procedure

1.

Connect PMC module carefully to PMC slot

2.

Make sure that 15 mm standoffs of PMC module cover mounting holes of the
blade.

3.

Place screws delivered with PMC module into mounting holes

4.

Fasten screws

Removal Procedure

1.

Remove screws

2.

Disconnect PMC module carefully from slot