Motorola ATCA-717 - Manual (Page 95)

BIOS Messages BIOS
PENT/ATCA−717 95
Message Corrective Action Explanation a
System battery is dead −
Replace and run SETUP The NVRAM (CMOS) clock
battery indicator shows the
battery is dead. Replace battery and run
setup to reconfigure
system.
System BIOS shadowed System BIOS copied to
shadow RAM None
System cache error − Cache
disabled RAM cache failed BIOS
test. BIOS disabled cache Contact your local sales
representative or FAE for
further support.
System CMOS checksum bad −
run SETUP System NVRAM (CMOS)
has been corrupted or
modified incorrectly,
perhaps by an application
program that changes data
stored in NVRAM (CMOS). Run setup and reconfigure
system either by getting
default values and/or
making your own
selections.
System RAM Failed at
offset: nnnn System RAM failed at offset
nnnn in the 64k block at
which the error was
detected. Check for correct memory
modules. Otherwise
contact your local sales
representative or FAE for
further support.
nnnn System RAM Passed nnnn is amount of system
RAM in KBytes
successfully tested None
System timer error Timer test failed Requires repair of system
blade
UMB upper limit segment
address: nnnn Address nnnn of the upper
limit of upper memory
blocks indicates released
segments of BIOS which
may be reclaimed by a
virtual memory manager. None
Video BIOS shadowed Video BIOS successfully
copied to shadow RAM None
Invalid System
Configuration Data − run
configuration utility − Enter setup and use
advanced configuration
option to reset
configuration data (due to
corrupted ESCD data).