Removal procedure, Cmc debug module – Motorola ATCA-717 User Manual
Page 52
Installation
On−Board Hardware Accessories
52
PENT/ATCA−717
3.
Plug CompactFlash into socket
4.
Close locking bow over CompactFlash disk
Note:
a
The locking bow must enclose the disk completely.
a
Removal Procedure
1.
Open locking bow
2.
Take CompactFlash disk
′s ends and pull CompactFlash disk carefully out of
socket
3.
Close locking bow again
CMC Debug Module
A CMC debug module is available as accessory kit for the blade. It is called
ACC/ATCA−CMC−MODULE and provides two serial and one keyboard/mouse
interface at its face plate. The CMC debug module is installed into PMC slot 4. For further
details refer to the
a
ACC/ATCA−CMC−MODULE Installation Guide.
aa