Multi-Tech Systems MTASR1-100 - Manual (Page 149)

Chapter 7 - Remote Configuration
149
Verify that the Communication Type field is set COM Port and the Select Port field is set for the Com
port of your local PC.
In the Dial String field, enter the AT command for dialing (ATDT) plus the phone number of the remote
RouteFinder
100 .
If your Modem Initialization String, Initialization Response, or Connect Response values are different than
the defaults in the dialog box, refer to your modem user documentation and change the default values to
match your modem.
Click on OK when you are satisfied with your selections.
6 The windows Program Manager menu is displayed.
Double click on the Router Configuration icon.
7 The Dialing Router dialog box is displayed while software is dialing the remote RouteFinder 100 .
8 The Reading Setup dialog box is displayed.
9 The Router Setup dialog box is then displayed. This is the dialog box of the remote RouteFinder 100 . You
can select any of the Protocol Stacks, Device drivers, or other buttons and change the configuration of the
remote RouteFinder
100 . Refer to the Menus Chapter (Chapter 5) for the definition of each dialog box and
field within a dialog box.