GE GFK-2489 - Manual (Page 30)

GFK-2489 Chapter 2 Tabletop Setup and Evaluation 2-9
2
Step 4—Configure the Remote Radio
The instructions below summarize essential Remote settings for tabletop testing. For detailed
log-in and menu navigation instructions, see chapter 4, Remote Radio Management.
Log-in and Configuration
Prepare the Remote for configuration as follows:
1. Connect a PC to the COM1 port on the radio.
2. Establish a terminal session (using HyperTerminal, for example) using the following data
parameters:
▪ 19200 bps
▪ 8 bits • no parity
▪ one stop bit (8N1)
▪ hardware flow control disabled
▪ VT100 emulation
NOTE: The exact parameters given above must be used for console terminal
communication. Improper settings are a common cause of difficulty.
3. Press ENTER several times to receive the entranet> prompt. (The COM1/ETH LED blinks
to indicate data communication.)
4. At the entranet> prompt, enter login. Press ENTER .
5. At the next prompt, enter the username (the default username is admin). Press ENTER .
6. At next prompt, enter the password (the default password is admin). Press ENTER . The
radio is now ready to accept commands.