GE GFK-1852 User Manual
Ge fanuc automation, Versamax serial to ethernet adapter
Table of contents
Document Outline
- Chapter 1 Introduction and Quick Start
- Chapter 2 VMSE Interfaces
- Chapter 3 Network Protocols
- Chapter 4 Configuration
- Configuration Steps
- Entering Serial Configuration Mode
- Entering Network Configuration Mode_
- VMSE’s IP Address
- Configuration Parameters
- SRTP/SNP Firmware – Configuration Setup
- Network/IP Settings
- IP Address
- Gateway IP Address
- Netmask
- Channel, Serial, and Protocol Setups
- SRTP/SNP Protocol Mode
- Serial Interface Configuration
- SNP T1 – T4 Timers
- SNP ID to IP Address Mapping ( only for SRTP/SNP Mode# 2)
- PassThru Firmware Configuration Setup
- Basic Parameters
- IP Address
- Gateway IP Address
- Netmask
- Telnet Configuration Password
- Channel 1 Parameters
- Baud Rate
- Interface Mode
- Flow Control
- Port Number
- Remote IP Address
- Remote TCP Port
- Connect Mode
- Automatic Connection Address
- Datagram Mode
- Modem Emulation Mode
- Disconnect Mode
- Force Telnet Mode
- Buffer Flushing
- Inactivity Timeout
- Pack Control
- Send Characters
- Telnet Terminal Type
- Modbus TCP/RTU Firmware Configuration Setup
- Network/IP Settings
- Serial and Mode Settings
- Modem Control Settings
- Advanced Modbus Protocol Settings
- Modbus ID to IP Address Mapping ( only used for Master)
- Chapter 5 Monitor Mode and Firmware Upgrade
- Chapter 6 Serial Line Interfaces
- Chapter 7 Technical Data
- Appendix A IP Addresses
- Appendix B Binary to HExadecimal Conversion Table
- Appendix C Declaration of Conformity
- Index