FUJITSU TeamPoS 3000 XL - Manual (Page 58)

TeamPoS 3000 XL and XL
2
Installation
5-12 Issue 3 D900000145
5.6 Installing Memory (XL2 Memory)
Caution: Be sure to observe all ESD precautions and power off procedures.
The TeamPoS 3000XL
2
motherboard has two memory sockets or slots and can use 512MB, 1GB
or 2GB SO DIMM memory in combinations. Memory on the Yosemite motherboard is mounted
horizontally rather than vertically as in previous motherboards.
1. Remove the rear panel (See Section 5.2).
2. Disconnect the AC power cord from the controller.
3. Remove the front panel.(See Section 5.1.1).Yellow LED should be off. (See Section 1.2).
4. Remove the motherboard assembly (See Section 5.2)
5. Insert memory (or additional memory) into the bottom socket. (There is only one way the
memory stick will fit.) With the motherboard seated in front as shown in the picture below,
angle the stick approximately 30° pressing to the left to make sure the stick is properly
seated. Then press down slightly on the edge of the stick that is elevated to make sure the
memory is properly seated.
6. The release latch for the memory stick will snap into place when the stick is properly
seated.