FUJITSU TeamPoS 3000 XL - Manual (Page 173)

TeamPoS 3000 XL and XL
2
Maintenance
7-40 Issue 3 D900000145
7.9.3.3 Combo Board Jumper Settings
The jumper block with 7 connectors (PRT1-7) and the right most of the two jumper blocks
(PW4) define the printer type to be used on COM3. The default for this jumper block is the
Fujitsu DT50 and CT10 printers. The default mode is with all 7 jumpers toward the wire harness.
Also with having the 7 jumpers towards the wire harness connectors they will support ESC POS
printers. The jumper settings are shown below.
Jumper Description Default
JP1
Power source selection for USB connector 1
1-2 Normal +5V
2-3 Standby +5V
1-2
JP2
Power source selection for USB connector 2
1-2 Normal +5V
2-3 Standby +5V
1-2
JP3
Power source selection for USB connector 3
1-2 Normal +5V
2-3 Standby +5V
1-2
JP4
Power source selection for USB connector 4
1-2 Normal +5V
2-3 Standby +5V
1-2
JP5
Power source selection for USB connector 5
1-2 Normal +5V
2-3 Standby +5V
1-2
JP6
Power source selection for USB connector 6
1-2 Normal +5V
2-3 Standby +5V
1-2
PW4
COM 4 Signal selection for D-Sub 9 connector
1-2 RI
3-4 +5V
5-6 Do not use
7-8 DCD
9-10 N.C.
1-2 Open
3-4 Short
5-6 Open
7-8 Open
9-10 Short
PRT1-7
COM 3
DT50 Series & TPG Printers Fujitsu (Asia)
2-3 1-2
5-6 4-5
8-9 7-8
11-12 10-11
14-15 13-14
17-18 16-17
20-21 19-20
2-3
5-6
8-9
11-12
14-15
17-18
20-21