FUJITSU TeamPoS 3000 XL - Manual (Page 207)

TeamPos 3000 XL and XL
2
BIOS XL Motherboard
D900000145 Issue 3 9-1
Chapter 9. BIOS Setup Procedures – Aurora Motherboard
If a motherboard is replaced in the field, it may be necessary to change the date
and time and setup the BIOS for the customer’s configuration. The following
information shows the default screens from the factory.
9.1 Opening CMOS Setup Screen
Turn ON power and press the “F2” key while the terminal goes through the power
on self test. (POST).
9.1.1 CMOS Settings
If this is a new motherboard it will be necessary to set the date and time before
releasing the terminal to the customer. To change the date and time, select
STANDARD CMOS FEATURES, then input the current date and time. Run
“LOAD OPTIMIZED DEFAULTS” then “SAVE & EXIT SETUP.” Changing
other default settings may be done at this time if the customer has settings other
than the default settings listed here. Changing settings that are not the default
or not set for specific customer needs may adversely effect the operation of
the unit.
In most cases, the CMOS default settings are adequate and do not require
changing. Follow the instructions on the screen to select STANDARD CMOS
SETUP.