FUJITSU TeamPoS 3000 XL - Manual (Page 43)

TeamPoS 3000 XL and XL
2
Site Preparation
D900000145 Issue 3 4-5
system. The terminals must not be directly connected to a power system
with impedance earthed neutral, i.e., an IT power system.
f. For pluggable equipment, the supply plug shall be connected as follows:
Black or Brown
Live (Hot)
White or Blue Neutral
Green or Yellow Ground/Earth
To the User:
•
DO read the operating instructions carefully before you attempt to
use this equipment.
•
DO ensure that the supply connector or isolator is readily accessible
to enable isolation of the equipment
•
DO ensure that a competently trained person checks that all
electrical connections (including the supply plug and any extension
leads) are properly made in accordance with the instructions.
•
DO NOT allow the supply cord to be positioned where it may be
snagged, trodden-on or stretched across a sharp edge.
•
DO NOT continue to operate the equipment if you have ANY doubt
about it working normally, or if it is damaged in any way. Instead,
switch it off and, if the equipment is pluggable, remove the supply
cord and contact your local service agent.
•
DO NOT remove any fixed covers unless you are qualified /
authorized to do so for the preparation of the equipment. There are
no user serviceable parts under the covers unless expressly
indicated in the equipment governing manual. Always remove the
supply plug from the power source before removing any covers, and
ensure ALL covers are replaced and correctly secured before re-
connecting the supply plug.
•
DO NOT obstruct any of the ventilation slots in the equipment.
Obstruction of these slots can cause overheating, reduce equipment
reliability and shorten the life of the equipment.
•
DO NOT expose the equipment to spilled liquids
•
DO NOT replace the supply cable with a different type than is
called up in the instruction documentation or supplied with the
equipment.