Kramer 4 x 4 Seamless AV Matrix Switcher/Multi-Scaler - Manual (Page 41)

34 VSM-4x4A – Controlling the VSM-4x4A
6.4 Operating the VSM-4x4A via Ethernet
You can connect to the VSM-4x4A via Ethernet using either of the following
methods:
•
Directly to the PC using a crossover cable (see Section 6.4.1 )
•
Via a network hub, switch, or router, using a straight-through cable (see
Section 6.4.2 )
Note : If you want to connect via a router and your IT system is based on IPv6,
speak to your IT department for specific installation instructions.
6.4.1 Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the VSM-4x4A directly to the Ethernet port on
your PC using a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the
VSM-4x4A with the factory configured default IP address.
After connecting the VSM-4x4A to the Ethernet port, configure your PC as follows:
1. Click Start > Control Panel > Network and Sharing Center .
2. Click Change Adapter Settings .
3. Highlight the network adapter you want to use to connect to the device and
click Change settings of this connection .
The Local Area Connection Properties window for the selected network
adapter appears as shown in Figure 14 .