3 configuring output parameters (output menu) – Kramer 4 x 4 Seamless AV Matrix Switcher/Multi-Scaler User Manual
Page 35
28
VSM-4x4A
–
Controlling the VSM-4x4A
6.2.3
Configuring Output Parameters (OUTPUT Menu)
Mode
Function
RESOLUTION
A to D
Set the output resolution to NATIVE (default), 480p, 576p, 720p50,
720p59, 720p60, 1080p24, 1080p50, 1080p60, 1024x768,
1280x800, 1280x1024, 1366x768, 1440x900, 1600x900,
1680x1050 or 1920x1200
The NATIVE resolution is read from OUT A. If the FW
cannot detect the OUT A native resolution or if it is not
supported, the resolution defaults to 1080p60
Seamless Matrix mode Set resolution on A
Applies to outputs A, B, C and D
Independent Matrix
mode
Set resolution separately for A, B, C and D
Dual PIP mode
Set resolution A for dual A (outputs A and
B)
Set resolution C for dual B (outputs C and
D)
Dual POP mode
Set resolution A for dual A (outputs A and
B)
Set resolution C for dual B (outputs C and
D)
Video wall 4x4, 1x4
Set resolution on A.
Applies to outputs A, B, C and D
QUAD mode
Set resolution on A.
Applies to outputs A, B, C and D
ASPECT RATIO
Set to Full, 4:3, 16:9 or Best Fit(default)
BORDERS
Available only for the DUAL and QUAD operation modes
Set to Show (all the borders), Only Selected (only the selected
output, default) or OFF
If Show is selected (a border around each image), the selected
output’s border appears slightly thicker
BORDER COLOR
Select RED, GREEN (default), BLUE, YELLOW, MAGENTA or
GREY
INPUT LABELS
Set input labels to ON or OFF (default)
By default the label is set to Source 1 for input 1, Source 2 for input
2 and so on
Note that the labels can be changed via the Web pages or RS-232
commands
OUTPUT LABELS
Set output labels to ON or OFF (default)
By default, labels are set to Output1, Output 2 and so on
Note that the labels (up to 12 characters) can be changed via the
Web pages or RS-232 commands
BEZEL
CORRECTION
In the Video Wall operation mode, use bezel correction to
compensate for the video wall monitor rims which create a non-
continuous image across the video wall
Set to OFF (default) or ON for the Video Wall operation mode only