IDK MSD-54 Series Command Guide - Manual (Page 93)

MSD-54 Series Users Guide (Command Guide)
93
@SEC Set control command (Display received data)
Command
format @SEC, no, delay, port, memo, length, command, timeout, retry, interval, retryover,
display
, delimiter
Return value
format @SEC, no, delay, port, memo, length, command, timeout, retry, interval, retryover,
display
, delimiter
Parameter no : Command number
1 to 32
delay :
0 to 999999
port : Output port
1 to 2047
bit10 bit9 bit8 bit7 bit6 bit5 bit4 bit3 bit2 bit1 bit0
Outp
ut
port
LOOP
BACK
LAN8
LAN
7 LAN
6 LAN
5 LAN
4 LAN
3 LAN
2 LAN
1 RS-232
C CH2 RS-232
C CH1
Specify “1” for the bit of the output port from which the command is sent (Since bit
15-11 are not used, always specify “0”). For example, if you send a command to
RS-232C CH1, specify “1”(0000000000000001 in binary). If sending a command to
LAN 1 and LAN 2, specify “12”(0000000000001100 in binary).
memo :
Up to 14 characters of 20 to 7D except 2C (,). “2 ASCII codes”
length : Data size of the sent command (the number of bytes)
0 to 30
command : Send command data
Specify length × 2 digits with 0 to 9, A to F, a to f = 4 bit per digit (in
hexadecimal)
timeout :
0 to 99999
retry :
0 to 99
interval : Interval between retries
0 to 99999
retryover : Processing at retry timeout
0 = Stop processing, 1 = Continue processing
display : Displaying received data
1 = In ASCII codes, 2 = In hexadecimals
delimiter :
Specify 2 digits of 0 to 9, A to F, a to f = 4 bit per digit (in hexadecimal) in order
to monitor delimiters
100 = Not monitor